I've also prepared two straps, (#13 on plans) that will be welded around the rear bushing legs, and two more (#14 on plans) to weld around tubes and between the two plates! I know.... will be more clear when i'll put everything together.
March 18, 2015
Landing gear bumper plates...and more!
Worked on landing gear bumper plates today, easy task to complete! plans call a number 44 drill bits to make holes, but i can't find one...so i used a 2.5mm drill bit, the difference in hole diameter from #44 to my 2.5mm is only 0.002 inch...so no make sense to worry about!
I've also prepared two straps, (#13 on plans) that will be welded around the rear bushing legs, and two more (#14 on plans) to weld around tubes and between the two plates! I know.... will be more clear when i'll put everything together.
I've also prepared two straps, (#13 on plans) that will be welded around the rear bushing legs, and two more (#14 on plans) to weld around tubes and between the two plates! I know.... will be more clear when i'll put everything together.
